252 Keysight M8070A Programming Guide
5 SCPI Command Reference
:INPut:CDR:SECond:PEAKing[?]
Syntax :INPut:CDR:SECond:PEAKing ‘identifier’, <NRf>
:INPut:CDR:SECond:PEAKing? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataIn1' or 'M*.DataIn2'
<NRf>: Adjust second order peaking of the CDR.
Return Range 0 dB to 3 dB
Description This command adjusts the second order peaking of the CDR which is valid
for the jitter transfer function. The default is 1 dB.
This SCPI is applicable for M8041A and M8051A.
Example :INP:CDR:SEC:PEAK ‘M1.DataIn1’, 0.5
To Next Page
Loading...
