314 Keysight M8070A Programming Guide
5 SCPI Command Reference
:PLUGin:OTIMing:SHOW:SMPoints[?]
Syntax :PLUGin:OTIMing:SHOW:SMPoints ‘identifier’, <OFF|ON|0|1>
:PLUGin:OTIMing:SHOW:SMPoints? ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name.
<OFF|ON|0|1>: Disable/enable viewing the measurement points.
Return Range 0|1
Description This command disables/enables viewing of the measurement points in the
GUI and associates it with a specific measurement name identifier. A 0 or
OFF value disables viewing and a 1 or ON value enables viewing of the
measurement points. The query returns the current value.
This SCPI is applicable for M8041A, M8051A, M8062A and M8046A.
Example :PLUG:OTIM:SHOW:SMP ‘MyMeasurement’, 1
:PLUGin:OTIMing:SHOW:UNIT[?]
Syntax :PLUGin:OTIMing:SHOW:UNIT ‘identifier’, <UINT|TIME>
:PLUGin:OTIMing:SHOW:UNIT? ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name.
<UINT|TIME>: Specify the timing units.
Return Range UINT|TIME
Description This command specifies the timing units and associates it with a specific
measurement name identifier. If UINT is specified then the timing units are
in UI. If TIME is specified then the timing units are in seconds. The query
returns the current value.
This SCPI is applicable for M8041A, M8051A, M8062A and M8046A.
Example :PLUG:OTIM:SHOW:UNIT ‘MyMeasurement’, unit
To Next Page
Loading...
Need help?
General
