Keysight Technologies J-BERT M8020A - Page 355

Keysight M8070A Programming Guide 355
SCPI Command Reference 5
:PLUGin:OLEVel:FETCh:NOISe:SNRatio:PPEak?
Syntax :PLUGin:OLEVel:FETCh:NOISe:SNRatio:PPEak? ‘identifier’ [,‘Location’]
Input
Parameters
‘identifier’: Specify the measurement name.
[,‘Location’]: ‘M*.DataIn1’ or ‘M*.DataIn2’ (optional).
Description This command returns the peak to peak value of the signal to noise ratio.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUGin:OLEVel:FETCh:NOISe:SNRatio:PPEak? ‘MyMeasurement’
:PLUGin:OLEVel:FETCh:NOISe:SNRatio:RMSquare?
Syntax :PLUGin:OLEVel:FETCh:NOISe:SNRatio:RMSquare? ‘identifier’ [,‘Location’]
Input
Parameters
‘identifier’: Specify the measurement name.
[,‘Location’]: ‘M*.DataIn1’ or ‘M*.DataIn2’ (optional).
Description This command returns the value of the root mean square of signal to noise
ratio.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUGin:OLEVel:FETCh:NOISe:SNRatio:RMSquare? ‘MyMeasurement’