Keysight Technologies J-BERT M8020A User Manual

Keysight M8070A Programming Guide 377
SCPI Command Reference 5
Description This command is used to set the number of measurement points for the
measurement specified by the measurement name identifier.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8046A.
Example :PLUG:JTOL:MSET:NPO ‘MyMeasurement’, 50
:PLUGin:JTOLerance:MSETup:MODE[?]
Syntax :PLUGin:JTOLerance:MSETup:MODE ‘identifier’,
<COMPliance|CHARacterize>
:PLUGin:JTOLerance:MSETup:MODE? ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name.
<COMPliance|CHARacterize>: Specify the measurement mode.
Return Range COMPliance|CHARacterize
Description This command is used to specify compliance or characterization as the
measurement mode for the measurement specified by the measurement
name identifier. Compliance is used for checking that a device passes the
minimum margin required for compliance to a standard. Characterization
tests a device for tolerance to jitter to establish the pass/fail amplitude at
each measurement point.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8046A.
Example :PLUG:JTOL:MSET:MODE ‘MyMeasurement’,CHAR
:PLUGin:JTOLerance:MSETup:CMARgin[?]
Syntax :PLUGin:JTOLerance:MSETup:CMARgin ‘identifier’, <NRf>
:PLUGin:JTOLerance:MSETup:CMARgin? ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name.
<NRf>: Specify the compliance margin.
Return Range -75% to 1000%

Keysight Technologies J-BERT M8020A Specifications

General

Brand	Keysight Technologies
Model	J-BERT M8020A
Category	Control Unit
Language	English