Keysight M8070A Programming Guide 399
SCPI Command Reference 5
Example The following example triggers a single eye diagram measurement step of
the measurement addressed with the measurement name identifier called
‘MyMeasurement’:
:PLUG:EDI:STEP ‘MyMeasurement’
:PLUGin:EDIagram:STOP
Syntax :PLUGin:EDIagram:STOP ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name to stop.
Description This command stops an eye diagram measurement addressed by the
measurement name identifier.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example The following example stops an eye diagram measurement with the
measurement name identifier called ‘MyMeasurement’:
:PLUG:EDI:STOP ‘MyMeasurement’
To Next Page
Loading...
