Keysight M8070A Programming Guide 427
SCPI Command Reference 5
:PLUGin:PSWEep:ACQuisition:SWPArameter[?]
Syntax :PLUGin:PSWEep:ACQuisition:SWPArameter 'Identifier',
<Sweep-Parameter>
:PLUGin:PSWEep:ACQuisition:SWPArameter? 'Identifier'
Input
Parameters
‘Identifier’: Specify the plugin name. For e.g. ‘ParameterSweep1’
<Sweep-Parameter>: Specify the sweep parameter present in current
location or group.
Description This command sets the sweep parameter to be swept amongst the list of
other parameters present in current location or group.
This query returns the current sweep parameter set on which sweep can
be performed.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A, M8045A
and M8046A.
Example :PLUG:PSWE:ACQ:SWPA 'ParameterSweep1', ”Delay”
:PLUGin:PSWEep:ACQuisition:SMODe[?]
Syntax :PLUGin:PSWEep:ACQuisition:SMODe 'Identifier', <ABSolute | RELative>
:PLUGin:PSWEep:ACQuisition:SMODe? 'Identifier'
Input
Parameters
‘Identifier’: Specify the plugin name. For e.g. ‘ParameterSweep1’
ABS | REL
Description This command sets the sweep mode. The choices are ‘ABSolute’ and
‘RELative’.
In the ‘ABSolute’ mode, the property will sweep from the value specified in
the ‘Sweep From’ parameter to a value specified in the ‘Sweep To’
parameter.
In the ‘RELative’ mode, the property will be sweep from a value relative to
the current value specified in the ‘Sweep From’ parameter to a value
relative to the current value specified in the ‘Sweep To’ parameter.
This query returns the current sweep mode.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A, M8045A
and M8046A.
Example :PLUG:PSWE:ACQ:SMOD 'ParameterSweep1', ABS
To Next Page
Loading...
Need help?
General
