Appendix E 253
Messages
Error Messages
E. Messages
L
101 License installation failed
This error occurs when an invalid license code is input during installation of the E5001
SSA-J license.
77 Load VBA program failed
This error occurs when loading a VBA program file fails.
M
20 Marker search failed
This error occurs when marker search fails.
-109 Missing parameter
The number of parameters is less than that required for the command, or the parameter has
not been entered.
N
351 No downconverter unit connected
This error occurs when the downconverter is not turned on or when the USB (USBTMC)
cable is not connected even though the downconverter is enabled. Disable the
downconverter, turn on the downconverter, or connect the USB (USBTMC) cable.
111 No signal found
This error message appears when a carrier is outside the selected frequency band or the
attenuator is improperly set during the execution of
Carrier to function. Set the attenuator
to 0 in case you measure a DUT whose output is less than -15dBm.
O
100 Option not installed
The command received has been ignored because of the mismatch between the contents of
an option for this instrument and the command.
This error is not generated by front key operations.
290 Oven Cold
This error occurs when PLL cannot be locked because the oven is not warm enough after
start-up the E5052B.
P
-220 Parameter error
When a parameter-related error other than Errors -221 through -229 occurs, that error is
displayed.
-108 Parameter not allowed
The number of parameters exceeds that required for the command.
To Next Page
Loading...
