Keysight N6705C - Page 38

:MANufacturer “<manufacturer>” Changes the manufacturer identity.
:DEFault Sets the manufacturer identity to the factory default.
:MODel “<model number>” Changes the model number.
:DEFault Sets the model number to the factory default.
:REBoot Reboots the instrument to its power-on state.
:SECurity
:IMMediate Clears all user memory and reboots the instrument.
:SET <data> Sets the instrument to the specified state.
:SET? Retrieves the current instrument state.
:TIME <hh>,<mm>,<ss> Sets the time of the system clock.
:VERSion? Returns the SCPI version that the instrument complies with.
TRIGger
:ACQuire
[:IMMediate] (@chanlist) Triggers the measurement immediately.
:CURRent
[:LEVel] <value>, (@chanlist) Sets the current trigger level.
:SLOPe POSitive|NEGative, (@chanlist) Sets the current trigger slope.
:SOURce <source>, (@chanlist) Selects the trigger source for the acquisition system:
BUS |CURRent<1-4> |EXTernal |PIN<1-7> |TRANsient<1-4> |VOLTage<1-4>
:TOUTput
[:ENABle] 0|OFF|1|ON, (@chanlist) Enables measurement triggers to be sent to a digital port pin.
:VOLTage
[:LEVel] <value>, (@chanlist) Sets the voltage trigger level.
:SLOPe POSitive|NEGative, (@chanlist) Sets the voltage trigger slope.
:ARB
:SOURce <source> Selects the trigger source for the arbitrary waveform:
BUS |EXTernal |IMMediate
:DLOG
[:IMMediate] Triggers the internal data logger immediately.
:CURRent
[:LEVel] <value>, (@chanlist) Sets the current trigger level of the data logger.
:SLOPe POSitive|NEGative, (@chanlist) Sets the current trigger slope of the data logger.
:SOURce <source> Selects the trigger source for internal data logging:
BUS |CURRent<n> |EXTernal |IMMediate |VOLTage<n> |ARSK |OOOK
:VOLTage
[:LEVel] <value>, (@chanlist) Sets the voltage trigger level of the data logger.
:SLOPe POSitive|NEGative, (@chanlist) Sets the voltage trigger slope of the data logger.
:ELOG
[:IMMediate] (@chanlist) Triggers the external data logger immediately.
:SOURce <source>, (@chanlist) Selects the trigger source for external data logging:
BUS |EXTernal |IMMediate| PIN<1-7>
:HISTogram (HISTogram commands only apply to models N6781A/82A/85A/86A)
1 Quick Reference
38 Keysight N6705C Operating and Service Guide