Keysight N6705C - Page 37

[:LEVel] <value>, (@chanlist) Sets the negative remote OV protection level. (only on N6784A)
:RANGe <value>, (@chanlist) Sets the output voltage range.
:SENSe
:SOURce INTernal|EXTernal, (@chanlist) Sets the state of the output remote sense relays.
:SLEW
[:IMMediate] <value>|INFinity, (@chanlist) Sets the voltage slew rate.
:MAXimum 0|OFF|1|ON, (@chanlist) Enables/disables the maximum slew rate override.
STATus
:OPERation
[:EVENt]? (@chanlist) Queries the operation event register.
:CONDition? (@chanlist) Queries the operation condition register.
:ENABle <value>, (@chanlist) Sets the operation enable register.
:NTRansiton <value>, (@chanlist) Sets the negative transition filter.
:PTRansiton <value>, (@chanlist) Sets the positive transition filter.
:PRESet Presets all Enable, PTR, and NTR registers.
:QUEStionable
[:EVENt]? (@chanlist) Queries the questionable event register.
:CONDition? (@chanlist) Queries the questionable condition register.
:ENABle <value>, (@chanlist) Sets the questionable enable register.
:NTRansiton <value>, (@chanlist) Sets the negative transition filter.
:PTRansiton <value>, (@chanlist) Sets the positive transition filter.
SYSTem
:CHANnel
[:COUNt]? Returns the number of output channels in a mainframe.
:MODel? (@chanlist) Returns the model number of the selected channel.
:OPTion? (@chanlist) Returns the option installed in the selected channel.
:SERial? (@chanlist) Returns the serial number of the selected channel.
:COMMunicate
:LAN|TCPip:CONTrol? Returns the initial socket control connection port number.
:RLSTate LOCal|REMote|RWLock Configures the remote/local state of the instrument.
:DATE <yyyy>,<mm>,<dd> Sets the date of the system clock.
:ERRor? Reads and clears one error from the error queue.
:GROup (GROup commands do NOT apply to models N678xA SMU)
:CATalog? Returns the groups that have been defined.
:DEFine (@chanlist) Group multiple channels to create a single channel.
:DELete (@channel) Remove the specified channel from the group.
:ALL Ungroups all channels.
:PASSword
:FPANel
:RESet Resets the front panel lockout password to zero.
:PERSona
Keysight N6705C Operating and Service Guide 37
1 Quick Reference