Keysight N6705C - Page 36

[:LEVel] <value>{,<value>}, (@chanlist) Specifies the setting for each list step.
:POINts? (@chanlist) Returns the number of list points (same as steps).
[SOURce:]
POWer
:LIMit?, (@chanlist) Sets the power limit on output channels.
[:SOURce]
RESistance (RESistance commands only on N6781A, N6785A)
[:LEVel]
[:IMMediate]
[:AMPLitude] <value>, (@chanlist) Sets the output resistance level.
:STATe 0|OFF|1|ON, (@chanlist) Enables/disables output resistance programming.
[SOURce:]
STEP
:TOUTput 0|OFF|1|ON, (@chanlist) Specifies whether a trigger out is generated when a transient step occurs.
[SOURce:]
VOLTage
[:LEVel]
[:IMMediate]
[:AMPLitude] <value>, (@chanlist) Sets the output voltage.
:TRIGgered
[:AMPLitude] <value>, (@chanlist) Sets the triggered output voltage.
:BWIDth LOW|HIGH1|HIGH2|HIGH3, (@chanlist) Sets the voltage bandwidth. (only on N678xA SMU)
:LIMit
[:POSitive]
[:IMMediate]
[:AMPLitude] <value>, (@chanlist) Sets the positive voltage limit. (only on N678xA SMU)
:COUPle 0|OFF|1|ON, (@chanlist) Sets the voltage limit tracking state. (only on N6784A)
:NEGative
[:IMMediate]
[:AMPLitude] <value>, (@chanlist) Sets the negative voltage limit. (only on N6784A)
:MODE FIXed|STEP|LIST|ARB, (@chanlist) Sets the transient mode.
:PROTection
[:LEVel] <value>, (@chanlist) Sets the over-voltage protection level.
:DELay
[:TIME] <value>, (@chanlist) Sets the over-voltage protection delay. (only on N6783A)
:REMote
[:POSitive]
[:LEVel] <value>, (@chanlist) Sets the positive remote OV protection level. (only on N678xA SMU)
:NEGative
1 Quick Reference
36 Keysight N6705C Operating and Service Guide