:SLEW
[:IMMediate] <value>|INFinity, (@chanlist) Sets the current slew rate. (only on N678xA SMU)
:MAXimum 0|OFF|1|ON, (@chanlist) Enables/disables the maximum slew rate override. (N678xA SMU)
[SOURce:]
DIGital
:INPut
:DATA? Reads the state of the digital control port.
:OUTPut
:DATA <value> Sets the state of the digital control port.
:PIN<1-7>
:FUNCtion <function> Sets the function of the pins.
DIO |DINPut |FAULt |INHibit |ONCouple |OFFCouple |TOUTput |TINPut
:POLarity POSitive|NEGative Sets the polarity of the pins.
:TOUTput
:BUS
[:ENABle] 0|OFF|1|ON Enables/disables BUS triggers on digital port pins.
[SOURce:]
EMULation <type>, (@chanlist) Specifies the emulation mode on models N678xA SMU.
PS4Q |PS2Q |PS1Q |BATTery |CHARger |CCLoad |CVLoad |VMETer |AMETer.
[SOURce:]
FUNCtion CURRent|VOLTage, (@chanlist) Specifies voltage priority or current priority mode. (only on N678xA SMU)
[SOURce:]
LIST
:COUNt <value>|INFinity, (@chanlist) Sets the list repeat count.
:CURRent
[:LEVel] <value>{,<value>}, (@chanlist) Specifies the setting for each list step.
:POINts? (@chanlist) Returns the number of list points (same as steps).
:DWELl <value>{,<value>}, (@chanlist) Specifies the dwell time for each list step.
:POINts? (@chanlist) Returns the number of list points (same as steps).
:STEP ONCE|AUTO, (@chanlist) Specifies how the list responds to triggers.
:TERMinate
:LAST 0|OFF|1|ON, (@chanlist) Determines the output value when the list terminates.
:TOUTput
:BOSTep
[:DATA] <Bool>{,<Bool>}, (@chanlist) Generates a trigger out at the Beginning Of STep
:POINts? (@chanlist) Returns the number of list points (same as steps).
:EOSTep
[:DATA] <Bool>{,<Bool>}, (@chanlist) Generates a trigger out at the End Of STep
:POINts? (@chanlist) Returns the number of list points (same as steps).
:VOLTage
Keysight N6705C Operating and Service Guide 35
1 Quick Reference
To Next Page
Loading...
