124 Keysight Technologies N9040B UXA Signal Analyzer Service Guide
Instrument Messages
Condition Messages
207 2 Burst not found;with
selected Time Slot
E The selected timeslot does not contain the
expected burst.
209 3 Timing Error E
209 3 Timing Error:No time
ref pilot burst
E The pilot burst used for time reference is not
active.
211 4 Carrier(s) incorrect
or missing
E In the PSA, this error was reported as one of
the following error numbers: 10165, 10173,
10178, 10419, 10421, 10535, 10560,
10642, 10648, 10650, 10960
213 5 Freq Out of Range E
213 5 Freq Out of Range;
System input (IF)
E One or more system input frequencies are
out of range. If using a frequency list, check
that all entries are valid for current
measurement mode.
213 5 Freq Out of Range;
External LO
E One or more external LO frequencies are out
of range. Check that the LO frequency limits
are set correctly and check the entered
measurement frequencies and
measurement mode.
215 6 Sync Error E W-CDMA: Cannot sync DPCCH pilot.
Cannot synchronize measurement with
DPCCH pilot for Power Control
measurement, because the pilot signal
cannot be found. Make sure DPCCH is
present in the W-CDMA uplink signal, and
that the slot format and scramble code are
set correctly.
215 6 Sync Error;No pilot
burst
E There is no Pilot burst detected.
215 6 Sync Error;Sync code
not found
E Synchronization code is not found in the
measured time slot.
215 6 Sync Error;No freq
ref pilot burst
E The pilot burst used for frequency reference
is not active.
215 6 Sync Error;Midamble
sync fail
E Failed to find the uplink slot, which caused
the synchronization with the midamble to
fail.
215 6 Sync Error;Preamble
length zero
E Burst type is “Data” or “Preamble” and the
measurement cannot find a Preamble
Err# Bit in
Status
Register
Message Error or
Warning
More Information
To Next Page
Loading...
Need help?
General
