Safety Notices
A CAUTION notice denotes a hazard. It calls attention to an operating procedure, practice, or the like that,
if not correctly performed or adhered to, could result in damage to the product or loss of important data.
Do not proceed beyond a CAUTION notice until the indicated conditions are fully understood and met.
A WARNING notice denotes a hazard. It calls attention to an operating procedure, practice, or the like
that, if not correctly performed or adhered to, could result in personal injury or death. Do not proceed bey-
ond a WARNING notice until the indicated conditions are fully understood and met.
Safety Symbols
Alternating current
Frame or chassis terminal
Standby supply. Unit is not completely disconnected from AC mains power when switch is off.
Risk of electric shock
Refer to accompanying documents
The CE mark is a registered trademark of the European Community.
The CSA mark with the 'c' and 'us' subscript indicates the instrument is certified to the applic-
able Canadian and United States of America standards respectively.
CAT II
(300V)
IEC Measurement Category II. Inputs may be connected to AC mains power (up to 300 VAC)
under Category II overvoltage conditions.
This product is marked with the ACMA RCM mark for compliance in Australia / New Zealand. A
copy of the Manufacturer’s Australia Declaration of Conformity for this instrument can be
obtained by contacting your local Keysight Technologies Sales Representative.
ISM 1-A This text indicates that the instrument is an Industrial Scientific and Medical Group 1 Class A product
(CISPR 11, Clause 4).
ICES/NMB-
001
This ISM device complies with Canadian ICES-001.
Cet appareil ISM est conforme à la norme NMB-001 du Canada.
Keysight Truevolt Series Operating and Service Guide
13
Safety and Regulatory Information
To Next Page
Loading...
Need help?
General
