Battery Replacement
This section describes the procedure for replacing the battery on the instrument's front panel.
Only qualified, service-trained personnel who are aware of the hazards involved
should remove instrument covers. Always disconnect the power cable and any
external circuits before removing the instrument cover. Some circuits are active and
have power applied even when the power switch is turned off.
Always disconnect all inputs, cords, and cables before disassembling the instrument.
Tools Required
l T20 Torx driver (most disassembly)
l Small, flat-blade screw driver (for prying)
Service and Repair
492
Keysight Truevolt Series Operating and Service Guide
To Next Page
Loading...
Need help?
General
