Keysight Truevolt Series User Manual

LAN Configuration
The following sections describe the primary front panel LAN configuration functions, including SCPI com-
mands where applicable. Some LAN configuration functions can be performed only via SCPI. See SYSTem
Subsystem - I/O Configuration for all LAN configuration commands, and see LAN Configuration Pro-
cedure to configure the LAN via the front panel.
Some LAN settings require you to cycle instrument power to activate them. The instru-
ment briefly displays a message when this is the case, so watch the screen closely as
you change LAN settings.
Resetting the LAN
You can clear the Web Interface password, turn DHCP on, and restart the LAN at any time:
l
Front Panel:[Utility] > I/O Config > LAN Reset
The message "Performing LAN Reset" is displayed while the LAN is reset.
l
SCPI: LXI:RESet
DHCP On/Off
DHCP (Dynamic Host Configuration Protocol) can automatically assign a dynamic IP address to a LAN
device. This is typically the easiest way to configure the instrument for LAN.
l This setting is non-volatile; it will not be changed by power cycling or *RST or SYSTem:PRESet.
l
Front Panel:[Utility] > I/O Config > LAN Settings > Modify Settings
Then set the first softkey to DHCP to use DHCP to automatically assign an IP address.
l
SCPI: SYSTem:COMMunicate:LAN:DHCP {ON|1|OFF|0}
l
If you change this parameter, you must either press the Apply Changes softkey (front panel) or send
SYSTem:COMMunicate:LAN:UPDate (remote interface) for the change to take effect.
To manually set an IP address, Subnet Mask, or Default Gateway, turn DHCP off, then change the IP setup
as described below.
Introduction to the Instrument
28
Keysight Truevolt Series Operating and Service Guide

Keysight Truevolt Series Specifications

General

Brand	Keysight
Model	Truevolt Series
Category	Measuring Instruments
Language	English