Execution Errors (-200…)
-203,"Command protected"
-203,"Command protected; feature not available on this model"
-203,"Command protected; instrument must be unsecured"
-203,"Command protected; large memory requires license MEM"
-203,"Command protected; License required"
-203,"Command protected; requires license DIG"
-203,"Command protected; requires license LAN"
-203,"Command protected; requires license SEC"
-203,"Secure option: Instrument security is unlocked"
-210,"Trigger error"
-211,"Trigger ignored"
-213,"Init ignored"
-214,"Trigger deadlock"
-220,"Parameter error"
-221,"Settings conflict"
-221,"Settings conflict; *TRG when TRIG:SOUR BUS not selected; trigger ignored"
-221,"Settings conflict; 10A current terminals not available with rear terminals; terminals set to 3A"
-221,"Settings conflict; CALC not allowed in current measurement function; CALC:STAT OFF set"
-221,"Settings conflict; CALC:SCAL:REF 0.0 not compatible with CALC:SCAL:FUNC PCT;
CALC:SCAL:STATE OFF set"
-221,"Settings conflict; cannot delete state selected and enabled for automatic power-on recall"
-221,"Settings conflict; cannot meet requested timing; SAMP:TIM changed"
-221,"Settings conflict; cannot meet requested timing; TRIG:DEL changed"
-221,"Settings conflict; histogram lower range > upper range; CALC:TRAN:HIST:RANG:AUTO ON set"
-221,"Settings conflict; histogram not allowed in current measurement function; CALC:TRAN:HIST:STAT
OFF set"
-221,"Settings conflict; internal trigger not allowed in current measurement function; TRIG:SOUR IMM
selected"
-221,"Settings conflict; limit test not allowed in current measurement function; CALC:LIM:STAT OFF set"
-221,"Settings conflict; lower limit > upper limit; CALC:LIM:UPP set to CALC:LIM:LOW value"
-221,"Settings conflict; offset compensation not allowed with low power ohms; low power disabled"
SCPI Programming Reference
464
Keysight Truevolt Series Operating and Service Guide
To Next Page
Loading...
Need help?
General
