Quick Performance Check
The quick performance check is a combination of internal self–test and an abbreviated performance test
(specified by the letter Q in the performance verification tests). This provides a simple method to achieve
high confidence in the instrument’s ability to functionally operate and meet specifications. These tests rep-
resent the absolute minimum set of performance checks recommended following any service activity.
Auditing the instrument’s performance for the quick check points (designated by a Q) verifies performance
for "normal" accuracy drift mechanisms. This test does not check for abnormal component failures.
To perform the quick performance check, do the following:
l Perform a self–test.
l
Perform only the performance verification tests indicated with the letter Q.
If the instrument fails the quick performance check, calibration or repair is required.
The Quick Performance Check can be limited by the factors described in the following section (Per-
formance Verification Tests).
Performance Verification
504
Keysight Truevolt Series Operating and Service Guide
To Next Page
Loading...
