Keysight Truevolt Series User Manual

Power-On and Reset State
These tables show factory default settings. Parameters marked with a bullet (•) are nonvolatile and are not
affected by power-on or system reset. Other parameters are volatile and are reset to the indicated values
at power-on or after *RST or SYSTem:PRESet.
The power-on/reset state may differ from these values if you have enabled
power-on state recall mode.
Factory Default Settings
Measurement Configuration Factory Setting
Function DC Volts
Range Autorange (for all functions)
Integration Time NPLC On, 10 power line cycles (PLC)*
Resolution Resolution equivalent to 10 PLC
Autozero On*
Aperture (34465A/70A only)* Off, 100 ms
Frequency or Period Aperture (Gate Time) 100 ms*
• Input Impedance • 10 MΩ (fixed for all DC voltage ranges)
AC Input Filter (bandwidth) 20 Hz (medium filter)
Temperature Transducer Type FRTD
RTD Reference Resistance 100 Ω
Nulls (individual functions) Off; reference = 0.0, auto reference enabled
(for all measurement functions)
Current Terminals 3 A
Secondary Measurements Off
Screen Shot Format PNG
Calibration Value 0.0
Current Switch Mode (34465A/70A only) Continuous
Resistance (2- and 4-wire) (34465A/70A only):
Offset Compensation Off
Low Power Measurements Off
Temperature (34465A/70A only):
Offset Compensation (2- and 4- wire RTD) Off
Low Power Measurements(2- and 4- wire RTD or thermistor) Off
Thermocouple (34465A/70A only):
Check Off
Reference Junction Temperature, Type, Adjust 0° C, Internal, 0° C
Thermocouple Type J
* For all DC measurement functions.
SCPI Programming Reference
474
Keysight Truevolt Series Operating and Service Guide

Keysight Truevolt Series Specifications

General

Brand	Keysight
Model	Truevolt Series
Category	Measuring Instruments
Language	English