Kikusui TOS5301 - Default Panel Memory Values

TOS5300 87
List of Default Settings
App
Default panel memory values
There are three panel memory entries. Initially, these entries all contain AC withstanding voltage
test conditions that comply with safety standards.
If you initialize the TOS5300 Series, the panel memory entries are also returned to their default
values.
Test timer on and off ON
Test time 0.1 s
Test time on and off ON
Judgment wait time 0.1 s
Test mode AC W
Panel memory
p.87
Interface setting USB
Configuration settings Test Mode Double Action OFF
Pass Hold 50 ms
Momentary OFF
Fail Mode OFF
Buzzer Volume
Level
Pass 3
Fail 5
Status Signal
Output
H.V ON OFF
Test OFF
Pass OFF
Upper Fail OFF
Lower Fail OFF
Ready OFF
Protection OFF
Power ON OFF
Date and Time Set Date and Time
No change
1
Calibration
Calibration Due Control 12 months
Calibration Protection OFF
1 The factory default settings are shown below.
Set Date and Time: Japan standard time at the time when the product left the factory.
Calibration Date: The date when the product was calibrated before it left the factory.
Item Setting after initialization
See
Memory number Setting Setting after initialization
1 to 3 Test mode ACW
Test voltage 0.00 kV
Limit voltage 5.5 kV
Upper limit 0.02 mA
Lower limit 0.01 mA
Test time 0.1 s
Start voltage OFF
Voltage rise time 0.1 s
Voltage fall time OFF
Output frequency 50 Hz