• How do I save the current test conditions
and use them later?
→”Panel Memory” p.42
• How do I start tests with a greater level of safety?
→”Double action feature” p.56
• How do I prevent unintentional key
operations from changing the test
conditions?
→”Using the Protection Cover” p.22
→”Locking panel operations (key lock)” p.40
• How do I perform consecutive tests by
switching test modes between each test?
→”Auto Test (AUTO TEST)” p.50
• How do I control the TOS5300 Series by
applying external signals?
→”SIGNAL I/O Connector” p.64
• How do I release the interlock feature?
→”Turning the Power On” p.23
• How do I check that the test leads are not
damaged (for example, that they have no
breaks)?
→”Pre-Test Inspection” p.72
• How do I check when calibration was last
performed?
→”Time Settings and Calibration
Management”
p.73
• How do I change the next scheduled
calibration date?
→”Time Settings and Calibration
Management”
p.73
• How do I set the system clock?
→”Time Settings and Calibration
Management”
p.73
To Next Page
Loading...
