Kinco FD5 AC series servo driver user manual
Chatper 9 Servo panel parameter list
111
Chatper 9 Servo panel parameter list
The EASY group allows users to quickly set commonly used control parameters.
Table 9-1 EASY parameters
Stores control ring
parameters
Store control ring parameters (excluding
motor parameters)
1, store all configuration parameters set
10. Initialize all configuration parameters
Configuration motor model
Control instructions can be configured
quickly by setting the instruction type.
Note: Changing the instruction type will
change the working mode and the
definition of the IO port.
0: Dual-pulse mode CW/CCW
1: pulse direction mode P/D
2: A/B phase pulse control mode
8: Communication control mode
When the instruction type is set to 0-2,
corresponding to working mode -4, DIN
will be configured to factory Settings.
When the instruction type is set to 8,
DIN4 and DIN5 are defined as positive
limit and negative limit respectively,
DIN7 is defined as origin mode, working
mode and control word are controlled by
communication.
Electronic gear
molecule [0]
This parameter is valid when EA02 is
written to 0-2.
The value is displayed in decimal by
default. Values over 10000 are displayed
in hexadecimal.
Note: See Table 4 for the decimal and
hexadecimal display methods.
Electronic gear
denominator [0]
The simulated speed
coefficient under
EASY
Set the analog speed factor
Digit tube from units to thousands (digit
tube from right to left) represents:
Bits: Load type, which affects control
ring parameters
0: no load
1: Flexible load (such as belt, etc.)
2: Rigid load (such as ball screw)
Tens: applications that affect control ring
parameters
0: point-to-point mode (positioning
control)
1: CNC mode (interpolation control)
2: master/slave mode
Hundred position: Set the limit switch
0: Use the current limit switch setting
To Next Page
Loading...
