Kinco FD5 Series - Chapter 4 Digital panel operation; 4.1 Panel operation

Kinco FD5 AC series servo driver user manual Chapter 4 Digital panel operation
41
Chapter 4 Digital panel operation
4.1Panel operation
After the servo system is installed and properly wired according to the specifications and precautions, the servo drive can be set up
for the specific application scenario.
Table 4-1 Panel operation instruction
Number/dot/button
Function
Dot ①
None
Dot②
Used to indicate whether the data is positive or negative. Dot2 on refers negative and off refers positive.
Dot③
When setting parameters, it is used to distinguish the current object group from the address data in the
object group；
When displaying the internal 32-bit data in real time, it is used to display the upper 16 bits of the current
32-bit data;
Indicates that the earliest error information in the error history is being displayed when the error history
record in F007 appears at the display.
Dot④
When displaying and adjusting parameters in real time, it is used to indicate the data display format: HEX
data when dot 4 is on and DEC data when dot 4 is off
Dot 4 indicates that the latest error information in the error history is being displayed when the error history
record in F007 appears at the display.
Dot⑤
Dot 5 on indicates that the data modification is confirmed successful
Dot 5 on indicates that the current displayed data is internal data
Dot 5 blinking means the power section of the drive is working
MODE
Switch function menu
；
When setting parameters, press briefly to switch the setting bit, press and hold to return to the last menu.
SET
Enter menu
；
Check the values of the parameters
；
Confirm the setting to access the next step
；
When the internal 32 bit data appears at the display, press and hold to switch high/low 16 bit.
▲
Press briefly increase the value slowly, press and hold increase the value rapidly
；
Switch data item.
▼
Press briefly decrease the value slowly, press and hold decrease the value rapidly；Switch data item.
P..L
Positive limit signal active
n..L
Negative limit signal active
Pn.L
Positive and negative limit signal active
FFF.F
The drive is not configured with the motor model
Blinking
Error