Kinco FD5 AC series servo driver user manual
Chatper 5 Kincoservo+ user guide
54
Figure 5-3 Init save reboot
Click the corresponding item to finish the necessary operation.
Note
After initializing the parameters, you need to save the control parameters to save the default
parameters in the drive.
5.3 Firmware update
In general, the firmware of the drive is always the latest version, but if the drive firmware needs to be updated for some reason,
please go to the menu bar "Controller" -> "Load Firmware ".
Figure 5-4 Load firmware
Click "Load File" to select the firmware file (.kinco), then click "Download" to start updating the drive firmware. After successful
download, please click the menu bar "Drive" -> "Drive Properties" -> "Software Version" to determine whether the firmware
download is successful.
Figure 5-5 Software version
Note
If the download is stopped for some reason, first power off, then power on the drive, select the firmware
version and start downloading, and finally turn on the communication and connect to the host computer.
To Next Page
Loading...
