Kinco FD5 Series - 2.2.4 Motor torque-speed characteristic curve; 2.2.4.1 200 W Motor Torque-Speed character curve; 2.2.4.2 400 W Motor Torque-Speed character curve

Kinco FD5 AC series servo driver user manual Chapter 2 Servo system installation requirements and notes
19
a suitable sleeve to push the oil seal into the cavity.
3. After successful installation, check whether the oil seal is tilted. The oil seal needs to fit with the motor
bearing cover, and the lip of the oil seal needs to be completely closed to ensure the tightness of the oil seal.
Cable
Please do not make cable bending or pull the cable. When using it, please do not make it too tight.
Connector
In terms of connectors, please note the following:
◆When connectors are connected. please make sure there is no foreign body such as trash or mental slices.
◆When connectors are connected into servo motors, please connect to one side of servo motor's main circuit
cable and make sure ground cable of main cable connecting stably. If operators first connect one side of
encoder cable, then, encoder may have some faults because of voltage difference between PEs.
◆During the process of wiring, please make sure pin arrangement is correct.
◆
Connector is made of resin. Please do not add pressure to avoid damage of connectors.
◆
When handling operations is done (cables are connected), please hold main body of servo motors. If
operators just hold cable to handle, it may cause connectors damage or make cable cut off.
◆If operators use bend cable, please do not add pressure to connectors during the processof wiring. If pressure
is added to connectors, it will cause connector damage.
2.2.4 Motor torque-speed characteristic curve
2.2.4.1 200W Motor Torque-Speed character curve
2.2.4.2 400W Motor Torque-Speed character curve
Instantaneous working
area
Continuous working area
Instantaneous working
area
Continuous working area
Instantaneous working
area
Instantaneous working
area
Continuous working area
Continuous working area