Kinco FD5 Series - 4.2 Panel operation instructions; 4.3 Easy Use Function; 4.3.1 Easy use operation step

Kinco FD5 AC series servo driver user manual Chapter 4 Digital panel operation
42
Note
Press SET setting determining
，
If the panel shows means failure setting. The reasons could be:
1.The setting value is out of the setting range of the parameter.
2.The drive is in the enabled state, the parameters cannot be changed. You need to cancel the enable state first.
4.2 Panel operation instructions
Set drive parameters and monitor real-time data as follows:
Figure 4-1 Parameters Setting
4.3 Easy Use Function
Easy Use is designed to quickly set control ring parameters for users, eliminating the tedious steps of servo debugging, and the
adjusted performance can meet most applications; In addition, an independent area is created to facilitate users to set commonly
used important parameters.
4.3.1 Easy use operation step
Step 1: Confirm EASY flow parameters one by one. After the EASY process is executed, run the machine, and if the performance
is ideal, there is no need to perform the tunE process. Otherwise, follow the tunE process
Step 2:The tunE process is the inertia measurement process. After the inertia is measured through the tn03, the drive changes the
rigidity class (tn01) according to the tuning result.
Step 3: Please run the machine, if the performance is not ideal, and then modify the rigidity level step by step through tn01, please
note that while adjusting, observe the machine performance.