Kinco FD5 Series - 5.4 Read;write controller configuration; 5.4.1 Read setting from controller; 5.4.2 Write setting to controller

Kinco FD5 AC series servo driver user manual
Chatper 5 Kincoservo+ user guide
55
5.4 Read/write controller configuration
For a large number of the same applications, in order to avoid setting drive parameters one by one, you can use this feature to
configure drives.
5.4.1 Read setting from controller
Click Tools->R/W Controller Configuration->Read Settings from Controller or click the button. The following window
appears
：
Figure 5-6 Read drive configuration
 Click Open List to select a parameter list file (.cdo). The parameter appears in the window.

Select the cdo file, the path contains two different cdo files:
errlist.cdo
，
ead only the historical fault information of the drive.
Kinco_Settings_Without Postable
，
Read drive control parameters and motor parameters.

Click Read Settings from Controller to get the Drive Value and Result, and then click Save to File to save the setting as a .cdi
file
Note

If the object does not exist in the drive, the result will be "False" and will be highlighted in red,
and only read parameters with a result of "true" will be saved in the.cdi file.
5.4.2 Write setting to controller
Click Tools->R/W Controller Configuration->Write Settings to Controller or click the button.
The following window appear button, the following window appears
Figure 5-7 Write drive configuration