Kinco FD5 Series - Environmental conditions; Technical requirements; Operator requirements; 2.2 Servo motor installation

Kinco FD5 AC series servo driver user manual Chapter 2 Servo system installation requirements and notes
17
Environmental conditions
Table 2-1 Environment requirements
Environment
Conditions
Working Temperature
0℃
～
40℃ (No ice)
Working Humidity
5～95%RH（No condensation）
Storage Temperature
-10℃
～
70℃
（
No ice
）
Storage Humidity
5~95%RH
（
No condensation
）
Protection Level
IP20
Install requirement
No sun and rain, no corrosive gas, no flammable gas, no oil and gas, dry and dust-free, and well
ventilated (such as electrical cabinets)
Altitude
There is no power limit when the altitude is below 1000m. When the working altitude is above 1000m,
the power usage needs to be reduced by 1.5% for every 100m rise.
Vibration
Under 5.9m/s2 10〜60Hz（Do not connect at the resonance point）
Technical requirements
In order to use the product correctly and safely, the following requirements should be always observed：

Operation of the product in accordance with the relevant safety regulations is permitted only if the connection and
environmental conditions specified in the product technical data and the technical requirements of all other connected
components comply with the product specifications.
 Please follow the instructions and read warnings in this document carefully.
Operator requirements

This product may only be operated by an electrical engineer familiar with the following regulations:
—Installation and operation of electrical control systems
—Applicable regulations for safe operation of engineering systems
—Applicable regulations for accident prevention and occupational safety
—User manual for the product
2.2 Servo motor installation
2.2.1 Installation requirements
Danger!
 Please install it indoor of no rain and direct sunlig
 Please do not use this product in the corrosive environment (Hydrogen sulfide, Sulfurous acid, Chlorine,
Ammonia, Sulfur, Chlorinated gas, Acid, Alkaline, Salt, etc), flammable gas, combustible and etc.
 Occasion (without Grinding fluid, Oil mist, Iron powder, cutting and etc.)
 Occasion (good ventilation, no Moisture, oil and water, no heat source such as stove.)

Occasion which is easy to be checked and cleaned.
 Occasion without vibration.

Please do not use motor in the closed environment.
 For installation spacing, please follow the requirements of this manual. Using life of motors depend on
working environment.

Please use screws with washers when installing the motor on the flange, otherwise the paint on the surface
of the motor may be scratched off.