Knick Stratos Multi E401N - Parameter Sets 1-5 (FW-E102)

Stratos Multi E401N
210
13.4.6 Parameter Sets 1-5 (FW-E102)
The FW-E102 add-on function must be activated in the device with a TAN for use of parameter sets 1-5.
➜
Option Activation, p. 47
Saving a Parameter Set on the Data Card
2 complete parameter sets (A, B) are stored in the device. Up to 5 parameter sets can be loaded to the
Data Card. To do so, a parameter set (1, 2, 3, 4, or 5) on the Data Card is overwritten by the device-inter-
nal parameter set A:
Parameter Setting

System Control

Parameter Sets

Save Parameter Set
01. Save to: Select the parameter set to be overwritten.
✓ The parameter set is saved as a file on the Data Card.
Loading a Parameter Set from the Data Card
A parameter set saved on the Data Card (1, 2, 3, 4, or 5) can be loaded to the device-internal parameter
set A. This overwrites parameter set A:
Parameter Setting

System Control

Parameter Sets

Load Parameter Set
01. Load from: Select the parameter set to be loaded.
✓ The parameter set is saved as parameter set A in the device.
See also
➜ Parameter Sets, p. 45