Stratos Multi E401N
80
5.9.3 Temperature Compensation of Process Medium
Note: If temperature compensation of the process medium is enabled, “TC” is shown on the display in
measuring mode.
The following are available for temperature compensation:
• Off
• Linear (enter temperature coefficient TC)
• EN 27888 (natural waters)
• Ultrapure water (with different trace impurities)
Trace impurities in ultrapure water
NaCl Neutral ultrapure water, for conductivity measurement in water processing downstream of gravel bed
filter
HCl Acidic ultrapure water, for conductivity measurement downstream of cation filter
NH
3
Ammoniacal ultrapure water
NaOH Alkaline ultrapure water
Settings can be changed in the TC Process Medium submenu:
Parameter Setting
[I] [II] … Cond
TC Process Medium
5.9.4 Concentration (TAN Option FW-E009)
With TAN option FW-E009, the substance concentration in percent by weight (wt%) can be
determined for H
2
SO
4
, HNO
3
, HCl, NaOH, NaCl, and Oleum from the measured conductivity and
temperature values. A custom solution can also be specified.
The menu is only shown if the TAN option is activated.
Parameter Setting
[I] [II] … Cond(I)
Concentration
See also
➜ Concentration Determination (FW-E009), p. 201
To Next Page
Loading...