Stratos Multi E401N
44
5.3.1 Transfer Configuration
All device settings can be saved on a memory card (Data Card):
Parameter Setting
System Control
Transfer Configuration
Note: The inserted Data Card is shown on the display.
• Select Save Configuration to write all the device settings (except passcodes) to the Data Card.
Backup file generated on the Data Card:
param/config.par
• Select Load Configuration to read all the device settings from the Data Card and apply them to the
device.
Transferring all Device Settings from One Device to Other Devices
Preconditions
• The devices all feature identical hardware.
• TAN options (add-on functions):
All required TAN options must be enabled before they can be transferred.
Steps
01. Parameter Setting
System Control
Transfer Configuration
02. Menu item Configuration: Save
03. Start the transfer with the right softkey: Execute.
✓ The device settings are saved to the Data Card.
04. Switch to the Maintenance
Open/Close Memory Card menu.
05. Terminate access to the memory card using the right softkey: Close.
06. Remove the Data Card.
✓ You can transfer the device settings to other, identically equipped devices.
07. Insert the Data Card containing the device settings in the next device to be configured.
08. Parameter Setting
System Control
Transfer Configuration
09. Menu item Configuration: Load
10. Start the transfer with the right softkey: Execute.
✓ The device settings are read from the Data Card and applied.
11. Switch to the Maintenance
Open/Close Memory Card menu.
12. Terminate access to the memory card using the right softkey: Close.
13. Remove the Data Card.
See also
➜ Memory Card, p. 153
To Next Page
Loading...