Korg microSTATION - Effects in each Mode; Routing and Effect Settings; Effect Settings for a Program

Using Effects
46
Effects in each mode
Program mode
Forprograms,youcanuseinserteffectstoprocessthe
finalsoundinthesamewaythatyouusetheFilterand
Amplifiertoprocessthesoundfromtheoscillators
(OSC1&2).Next,themastereffectsareusedtocreate
overallambiencesuchasreverb,andyouusetheto
tal
effecttomakefinaladju
stments.
Combination and Sequencer modes
InCombinationandSequencermodes,youcaninsert
effectstoprocessthesoundofeachtimbre/track
program.Thenyoucanusethemastereffectstocreate
overallambience,andusethetotaleffecttomakefinal
adjustments.
InCombinationmode,youcanadjustthesesettingsfor
eachcombination,andinSequencermodeyoucan
adjustthemforeachsong.
InSequencermode,yo
ucanswitchbetweeneffectsor
modifytheeffectparametersandrecordthese
changes,sothateffectswillswitchautomaticallyor
effectparameterswillbemodifiedautomaticallyasthe
songplaysback.
Routing and effect
settings
Theinserteffects,mastereffects,andtotaleffectthat
areavailableineachmodehavethesamestructure,
buttheroutingsettingswilldeterminehowthe
program’soscillators,thecombination’stimbres,orthe
song’strackswillbesenttoeachoftheinserteffects,
mastereffects,andtotaleffects.Herewe’llexpla
in
howtoadjustroutingsettingsineachmode
,andhow
toedittheeffectsettings.
Effect settings for a program
Routing
1. AccessthePROGEDIT:FXRouting“Bus”
parameter.
2. “Bus”specifiesthebuswheretheoutputfromthe
oscillatorswillbesent.Herewe’llchooseIFX1so
thattheoutputoftheoscillatorswillbesentto
inserteffect1.
L/R:Theoscillatoroutputwillnotbesenttoan
inserteffect.Itwillpassthroughthetotaleffect,and
thenbesenttoOUTPUTL/MONOandR.
IFX1–IFX5:Theoscillatoroutputwillbesentto
inserteffect1–5.
Off:Theoscillatoroutputwillnotbesentto
OUTPUTL/MONOorR,ortoinserteffects1–5.
(Choosethisifyouwanttoconnecttheoscillator
outputtothemastereffectsinseries,atthesend
lev
elsspecifiedby“OSC1Send1,”“OSC1Send2,”
“OSC2Send1,”and“OSC2Send2.”)
Oscillator1 Filter1 Amplier1
Oscillator2 Filter2 Amplier2 Insert Eect 1–5 Total Eect
Master Eect 1, 2
Return
OUTPUT
L/MONO, R
Send
Program mode
Timbre 1 /MIDI Track 1
Timbre 16 /MIDI Track 16
Insert Eect 1–5 Total Eect
Master Eect 1, 2
Return
OUTPUT
L/MONO, R
Send
Combination, Sequencer mode