Korg Triton-Rack

COMBI
1.1
2.12.22.33.13.23.33.44.14.24.34.46.17.17.27.3
39
These settings specify the keyboard range in which each
timbre will sound.
The top/bottom key parameters specify the range of notes
in which timbres 1–8 will sound, and the top/bottom slope
parameters specify the range over which the original vol-
ume will be reached.
By setting timbres of different sounds to ranges that do not
overlap, you can play different sounds in different ranges of
the keyboard (Key Split).
By setting the ranges to overlap, you can play two or more
sounds with a single note (Layer).
If you set the slopes (the grayed portion) to overlap, the
sounds will overlap, and the proportion of the overlap will
change according to the keyboard location (Positional
Cross-fade).
3.3–1: Key (Key Zone)
3.3–1a: Key Zone Map (1)
This displays the range of note data that will sound the cur-
rently selected track. The range of notes sounded is shown
as a line, and the slope portion is shaded.
3.3–1b: Top Key, Bottom Key
Top Key [C–1...G9]
Specifies he top key (upper limit) of the notes that will
sound each timbre 1–8.
Bottom Key [C–1...G9]
Specifies the bottom key (lower limit) of the notes that will
sound each timbre 1–8.
You can also set this parameter by holding down the
[ENTER] key and playing a note on a connected MIDI
instrument.
It is not possible to set the bottom key above the top key
of the same timbre. Nor is it possible for the top and
bottom slopes to overlap.
How volume will change according to keyboard location
■ 3.3–1c: UTILITY
☞ “Write Combination,” “Solo Selected Timbre” (1.1–1d)
3.3–2: Slope (Key Slope)
3.3–2a: Top Slope, Bottom Slope
Top Slope [00...72]
Specifies the range of keys (12 is one octave) over which the
volume will be reached starting from the top key.
0: The volume will be at the original level from the top key.
12: The volume will increase gradually as you play down-
ward, and will reach the original volume one octave below
the top key.
60: The volume will increase gradually as you play down-
ward, and will reach the original volume five octaves below
the top key.
Bottom Slope [00...72]
Specifies the range of keys (12 is one octave) over which the
volume will be reached starting from the bottom key.
0: The volume will be at the original level from the bottom
key.
12: The volume will increase gradually as you play upward,
and will reach the original volume one octave above the bot-
tom key.
60: The volume will increase gradually as you play upward,
and will reach the original volume five octaves above the
bottom key.
■ 3.3–2b: UTILITY
☞ “Write Combination,” “Solo Selected Timbre” (1.1–1d)
3.3–3: Review
3.3–3a: Key Zone Map (All)
T1...T8
This displays the range of note data that will sound timbres
1–8. The range of notes sounded is shown as a line, and the
slope portion is shaded.
■ 3.3–3b: UTILITY
☞ “Write Combination,” “Solo Selected Timbre” (1.1–1d)
COMBI 3.3: Ed–Key Zone
3.3–1a
3.3–1b
3.3–1c
Bottom Key Top Key
Key
Volume
Bottom Slope Top Slope
3.3–2a
3.3–2b
3.3–3a
3.3–3b