230
A
Are you sure ?
C
Can’t copy/swap double size effect
Completed
D
Destination and source are identical
Destination is empty
Destination multi is empty
Destination multisample already exists
Destination multisample and source multisample are
identical
Destination sample already exists
Destination sample data used in source sample
Destination sample is empty
Directory is not empty
Disk not formatted
E
Error in formatting medium
Error in reading from medium
Error in writing to medium
F
File already exists
Various messages
Meaning: This message asks you to confirm execution. To
execute press the [F8] (“OK”) key. To cancel, press
the [F7] (“Cancel”) key.
Meaning: When copying or swapping an insertion effect,
you attempted to place a double-size effect in
IFX1 or IFX5.
Action: Modify your settings so that a double-size effect is
not moved to IFX1 or 5, and execute again.
Meaning: Execution of the command ended normally.
Meaning: When copying or bouncing, the same Multi or
pattern was selected for both the source and desti-
nation.
Action: Select a different Multi or pattern for the source
and destination.
Meaning: When editing, the pattern that was specified as
the destination contains no musical data.
Action: Select a pattern that contains musical data.
Meaning: The multi that was specified as the copy destina-
tion or bounce destination does not exist.
Action: Execute the Create New Multi command in the
dialog box that appears when a new multi is
selected before copying or bouncing.
Meaning: A multisample already exists at the destination
(save location) multisample.
Action: Either delete the multisample at the destination
(save location), or change the save destination
multisample number.
Meaning: The same multisample is selected for the source
and destination.
Action: Select different multisamples for the source and
destination.
Meaning: A sample already exists at the destination (save
location).
Action: Either delete the sample at the destination (save
location), or change the save destination sample
number.
Meaning: Since the sample data at the destination (save
location) is also used by the source sample, it can-
not be overwritten.
Action: Without using Overwrite, specify a different sam-
ple for the destination (save location).
Meaning: The sample for editing is empty.
Meaning: When deleting a directory, files or directories exist
within that directory.
Action: Delete all directories or files within the directory.
Meaning: When you attempted to perform a high-level for-
mat (quick format) of media, the media had not
been physically formatted yet.
Action: Execute the Disk mode Utility “Format” to physi-
cally format the media (full format).
Meaning: An error occurred while performing a physical
format (full format) or high-level format (quick
format) of the media.
Action: Use other media.
Meaning: An error occurred while reading data from a
medium.
Action: Execute the reading operation once again. If the
same error occurs, it is possible that the data on
the disk has been damaged.
Meaning: An error occurred while writing data to a
medium. (Verify error)
Action: It is possible that the floppy disk has been physi-
cally damaged. Try another disk. Avoid using the
floppy disk that produced the error.
Meaning: When executing a Create Directory or File
Rename operation, a directory or file of the same
name already exists on the disk.
Meaning: When executing the Disk mode Utility “Copy”
command without using wild cards, the copy des-
tination contained a file of the same name as the
copy source.
Meaning: Meaning: When you executed the Disk mode util-
ity “Save Sampling Data” with a setting of All, All
Multisamples, All Samples, or One Multisample, a
directory with the same name as the directory that
the TRITON-Rack attempted to create already
existed on the disk.
Action: Either delete the existing directory or file, or spec-
ify a different filename.
To Next Page
Loading...
