Korg Triton-Rack

MULTI
1.1
2.22.33.13.23.33.44.14.24.34.45.16.17.17.27.3
57
3.3–3: Slp..8 (Key Slope T01–08)
3.3–4: Slp..16 (Key Slope T09–16)
3.3–3(4)a: Top Slope, Bottom Slope
Top Slope [00...72]
Specifies the key range (12 is one octave) from the top key of
track 1–8, 9–16 until the original volume is reached.
Bottom Slope [00...72]
Specifies the key range (12 is one octave) from the bottom
key of track 1–8, 9–16 until the original volume is reached.
■ 3.3–3(4)b: UTILITY
☞ “Memory Status,” “Rename Multi,” “Delete Multi,”
“Copy From Multi,” “Copy From Combi,” “Load Tem-
plate Multi,” “Save Template Multi” (1.1–1c)
3.3–5: Review
3.3–5a: Key Zone Map (All)
T1...T16
This shows the range of note data that will be sounded by
tracks 1–16. The note range that will be sounded is shown as
a line, and the slope portion is grayed.
■ 3.3–5b: UTILITY
☞ “Memory Status,” “Rename Multi,” “Delete Multi,”
“Copy From Multi,” “Copy From Combi,” “Load Tem-
plate Multi,” “Save Template Multi” (1.1–1c)
Specifies the range of velocities that will sound each track.
Set the Top/Bottom Velocity parameters to set the range of
velocities that will sound tracks 1–8 and 9–16, and set the
Top/Bottom Slope parameters to specify the range over
which the volume will change.
These settings do not affect MIDI transmission. All note
data produced by RPPR and the arpeggiator will be
transmitted.
3.4–1: Vel..8 (Velocity Zone T01–08)
3.4–2: Vel..16 (Velocity Zone T09–16)
3.4–1(2)a: Velocity Zone Map (1)
This shows the range of velocities that will sound the cur-
rently selected track. The velocity range that will be
sounded is shown as a line, and the slope portion is grayed.
3.4–1(2)b: Top Velocity, Bottom Velocity
Top Velocity [1…127]
Specifies the maximum velocity that will be sounded by
each track 1–8, 9–16.
Bottom Velocity [1…127]
Specifies the minimum velocity that will be sounded by each
track 1–8, 9–16.
The value of these parameters can also be set by hold-
ing down the [ENTER] key and playing a note on a con-
nected MIDI instrument.
■ 3.4–1(2)c: UTILITY
☞ “Memory Status,” “Rename Multi,” “Delete Multi,”
“Copy From Multi,” “Copy From Combi,” “Load Tem-
plate Multi,” “Save Template Multi” (1.1–1c)
3.3–3a
3.3–3b
3.3–5a
3.3–5b
MULTI 3.4: Vel Zone (Velocity Zone)
3.4–1a
3.4–1b
3.4–1c