158
a: OSC Mode, b: Note Interval, c: Fine
The “OSC Mode” parameter selects the oscillator operation mode.
When Note (Key Follow) is selected, the oscillator’s frequency is
determined based on the note number, allowing you to use it as
an octaver. The “Note Interval” parameter sets the pitch offset
from the original note number by semitone steps. The “Fine”
parameter allows you to fine-tune in steps of cents.
e: Envelope Pre LPF
This parameter sets the upper limit of the frequency range to
which very low harmonics are added. Adjust this parameter if
you do not want to add lower harmonics to the higher range.
013: Talking Mod
(Talking Modulator)
This effect adds an unusual character, like a human voice, to
the input signal. Modulating the tone via dynamic modula-
tion, you can create an interesting effect that sounds as if the
guitar or synthesizer is talking.
d: Top, d: Center, d: Bottom
These parameters assign vowels to the top, center, and bottom
position of the controller.
E.g.: When “Top”=A, “Center”=I, and “Bottom”=U:
If “Sweep Mode” is set to Dmod and “Control Src” is set to JSX,
moving the joystick of a connected MIDI instrument from the far
right to the far left will make the voice change from “a” to “i” then
“u.”
If Sweep Mode is set to LFO, the sound will change cyclically
from “a” to “i,” “u,” “i,” then “a.”
e: Formant Shift
This parameter adjusts the frequency level to which the effect is
applied. If you wish to apply the effect to a higher-range sound,
set this parameter to a higher value; to apply the effect to a lower-
range sound, set this to a lower value.
h: Resonance
This parameter sets the intensity of resonance for the voice pat-
tern. A larger value will add more character to the sound.
e
Envelope Pre LPF 1...100
Sets the upper limit of the frequency range for which very low har-
monics are added
☞
f
Envelope Sens (Envelope Sensitivity) 0...100
Sets the sensitivity with which very low harmonics are added
g
Envelope Shape
Sets the oscillator’s volume envelope curve
–100...+100
h
W/D (Wet/Dly) Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
(Source) Off...Tempo
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance
–100...+100
a
Sweep Mode Dmod, LFO
Switches between modulation source control and LFO control
b
Voice Control Bottom, 1...49, Center, 51...99, Top
Voice pattern control
c
Control Src (Control Source) Off...Tempo
Selects the modulation source that controls the voice pattern
d
Top (Voice Top)
Selects a vowel sound at the top end of control
A, I, U, E, O
☞
Center (Voice Center)
Selects a vowel sound in the center of control
A, I, U, E, O
☞
Bottom (Voice Bottom) A, I, U, E, O
Selects a vowel sound at the bottom end of control
☞
e
Formant Shift –100...+100
Sets the frequency to which the effect is applied
☞
f
lfoF (LFO Frequency) 0.02...20.00Hz
Sets the LFO speed
☞ Fx:009,
(Source)
Selects the modulation source of LFO speed
Off...Tempo
(Amount) –20.00...+20.00Hz
Sets the modulation amount of LFO speed
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Right
Wet / Dry
Wet / Dry
+
D
-mod
Voice Top: A
Voice Center: I
Voice Bottom: U
A
-
I
-
U
-
E
-
O
Talking Modulator
LFO
D-mod
LFO
Sweep Mode
g
BPM/MIDI Sync Off, On
Switches between using the frequency of the LFO speed and using
the tempo and notes
☞ Fx:009,
BPM
Selects MIDI Clock and assigns tempo
MIDI, 40...240
☞ Fx:009
Base (Base Note)
Selects the type of notes that specify the LFO speed ☞ Fx:009
Times 1...16
Sets the number of notes that specify the LFO speed
☞ Fx:009
h
Resonance
Sets the Level of resonance of the voice pattern
0...100
☞
i
W/D (Wet/Dly) Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
(Source) Off...Tempo
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance
–100...+100
+ Max
Zero
D
-mod
– Max
Voice Bottom
Voice Center
Voice Top
U
I
A
A
O
E
JS X
Rbn#16
JS +Y#1
JS –Y#2
etc…
Zero
+ Max
Talking Modulator Control
To Next Page
Loading...
