Korg Triton-Rack

178
a: Ctrl Target
This parameter selects no level control, delay output control
(effect balance), or feedback amount control.
a: Pol, b: Threshold, b: Offset, c: Attack, d: Release
The “Offset” parameter specifies the value for the “Ctrl Target”
parameter (that is set to None), expressed as the ratio relative to
the parameter value (the “W/D” value with “Ctrl Target”=Out, or
the “Feedback” value with “Ctrl Target”=FB).
When “Pol” is positive, the “Ctrl Target” value is obtained by
multiplying the parameter value by the “Offset” value (if the
input level is below the threshold), or equals the parameter value
if the input level exceeds the threshold.
When “Pol” is negative, Ctrl Target value equals the parameter
value if the input level is below the threshold, or is obtained by
multiplying the parameter value by the “Offset” value if the level
exceeds the threshold.
The “Attack” and “Release” parameters specify attack time and
release time of delay level control.
048: St.AutoPanDly
(Stereo Auto Panning Delay)
This stereo delay effect pans the delay sound left and right
using the LFO.
049: LCR BPM Delay
(L/C/R BPM Delay)
The L/C/R delay enables you to match the delay time with
the song tempo. You can also synchronize the delay time with
the arpeggiator or sequencer. If you program the tempo
before performance, you can achieve a delay effect that syn-
chronizes with the song in real-time. Delay time is set by
notes.
a
L Delay (L Delay Time)
Sets the delay time for the left channel
0.0...680.0ms
b
R Delay (R Delay Time)
Sets the delay time for the right channel
0.0...680.0ms
c
L Feedback
Sets the feedback amount for the left channel
–100...+100
d
R Feedback
Sets the feedback amount for the right channel
–100...+100
e
HiDamp (High Damp)
Sets the damping amount in the high range
0...100%
☞ Fx:043
LoDamp (Low Damp)
Sets the damping amount in the low range
0...100%
☞ Fx:043
f
LFO Wave (LFO Waveform)
Selects LFO Waveform
Tri, Sine
Shape (LFO Shape) –100...+100
Determines how much the LFO waveform is changed
☞ Fx:020
g
LFO Phase –180...+180deg
Sets the LFO phase difference between the left and right
☞ Fx:034
Dynamic Delay
Threshold
Dry
Envelope
Wet
Control Target=Out
Polarity= (–)
Wet
Control Target=Out
Polarity= (+)
Delay Time
Time
(Ducking Delay)
Release
Attack
Level
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
LFO Phase
LFO Shape
Pan
Pan
LFO: Tri / Sin
Depth
Delay
Delay
High Damp Low Damp
High Damp
Low Damp
Feedback
h
Pan Freq (Panning Frequency)
Sets the panning speed
0.02...20.00Hz
i
Pan Dep (Panning Depth)
Sets the panning width
0...100
(Source) Off...Tempo
Selects the modulation source for the panning width
(Amount)
Set the modulation amount of the panning width
–100...+100
j
W/D (Wet/Dly) Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
(Source) Off...Tempo
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance
–100...+100
a
BPM
Selects MIDI Clock and assigns tempo
MIDI, 40...240
☞,
b
L Bs (L Delay Base Note)
                 
Selects the type of notes to specify the delay time for TapL
☞,
Times 1...16
Sets the number of notes to specify the delay time for TapL
☞
Level
Sets the output level of TapL
0...50
c
C Bs (C Delay Base Note)
                 
Selects the type of notes to specify the delay time for TapC
☞,
Times 1...16
Sets the number of notes to specify the delay time for TapC
☞
Level
Sets the output level of TapC
0...50
d
R Bs (R Delay Base Note)
                 
Selects the type of notes to specify the delay time for TapR
☞,
Times 1...16
Sets the number of notes to specify the delay time for TapR
☞
Level
Sets the output level of TapR
0...50
e
C Fb (C Delay Feedback)
Sets the feedback amount of TapC
–100...+100
(Source) Off...Tempo
Selects the modulation source for the TapC feedback
(Amount) –100...+100
Sets the modulation amount of the TapC feedback
f
Time Over? > ----, OVER!
Displays an error message when the delay time exceeds the upper
limit
☞
C Delay
R Delay
Left
Right
Feedback
Spread
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In -Stereo Out
Input Level D-mod
High Damp
Low Damp
L Delay
Input Level D-mod
+
Level
Level
Level
Tempo
BPM
BPM
Base Note x Times
Base Note x Times
Base Note x Times