Korg Triton-Rack

MULTI
1.1
2.22.33.13.23.33.44.14.24.34.45.16.17.17.27.3
71
☞ For details on the master effects, refer to p.146.
7.3–1: Setup
Here you can select the type of master effects, turn them on/
off, and make chain and master EQ settings.
This is the same as Program mode with the exception of
“MFX1 Control Ch,” “MFX2 Control Ch,” and “MEQ Con-
trol Ch.” (
☞PROG 7.3: Ed-MasterFX)
7.3–1a: Master FX Setup
MFX1 On/Off, MFX2 On/Off [Off, ON]
Master Effect 1, 2 [000...089: name]
Rtn 1, 2 (Return 1, 2) [000...127]
This is the same as in Program mode. Refer to “PROG 7.3–1:
Setup.” However, unlike Program mode, the master effects
will be controlled by the MIDI channel specified by “MFX 1,
2 Control Ch.” The control changes used are the same as in
Program mode.
MFX1, 2 Control Ch [Ch01...16, G ch]
Specifies the MIDI channel that will control dynamic
modulation (Dmod) for the master effects.
G ch: The effect will be controlled on the global MIDI chan-
nel “MIDI Channel” (GLOBAL 2.1–1a).
7.3–1b: Master FX Chain
MFX Chain
Direction (Chain Direction)
[MFX1→MFX2, MFX2→MFX1]
Signal (Chain Signal) [LR Mix, L Only, R Only]
Level (Chain Level) [000...127]
This is the same as in Program mode. Refer to “PROG 7.3–1:
Setup.”
7.3–1c: Master EQ Gain [dB]
Low [–18.0...+18.0]
Mid [–18.0...+18.0]
High [–18.0...+18.0]
This is the same as in Program mode. (☞PROG 7.3–1: Setup)
7.3–1d: MEQ Ctrl
MEQ Ctrl (MEQ Control Ch) [Ch01...16, G ch]
Specifies the MIDI channel that will control dynamic
modulation (Dmod) for the master EQ.
G ch: The effect will be controlled on the global MIDI chan-
nel “MIDI Channel” (GLOBAL 2.1–1a).
■ 7.3–1e: UTILITY
☞ “Memory Status” (1.1–1c), “Select by Category” (PROG
7.3–1d)
Copy Master Effect
(☞PROG 7.3–1d)
Note, the MIDI control channel specified in “Control Chan-
nel” of the MFX 1 and 2 pages will not be copied.
Swap Master Effect
(☞PROG 7.3–1d)
Note, the MIDI control channel specified in “Control Chan-
nel” of the MFX 1 and 2 pages will not be swapped.
7.3–2: MFX1
7.3–3: MFX2
Here you can set the parameters of the “Master Effect1” and
“Master Effect2” effects that were selected in the Setup page
(
☞p.151).
■ 7.3–2(3)a: UTILITY
☞ “Memory Status” (1.1–1c)
MULTI 7.3: Master FX
7.3–1a
7.3–1b
7.3–1e7.3–1c7.3–1d
7.3–2a