KTM 1190 RC8 R User Manual

13 WHEELS, TIRES 198
Preparatory work
– Raise the rear of the motorcycle with lifting gear. ( p. 167)
– Remove the rear wheel. ( p. 194)
C00342-01
Main work
– Remove the rear sprocket carrier.
– Check the rear hub for damage and wear.
» If the rear hub cush drive is damaged or worn:
– Change the rubber damper.
– Position the rear sprocket carrier.
Info
A set of bolts and shock absorbers should have as little free travel as possible to
increase the service life of the shock absorbers.
Finishing work
– Install the rear wheel. ( p. 195)
– Remove the rear of the motorcycle from the lifting gear. ( p. 167)
– Check the chain tension. ( p. 173)
13.6 Checking the tire condition
Warning
Danger of accidents Uncontrollable vehicle handling in the event of a flat tire.
– In the interest of safety, replace damaged or worn tires immediately. (Your authorized KTM workshop will be pleased to help.)
Warning
Danger of crashing Poor vehicle handling due to different tire tread patterns on front and rear wheels.
– The front and rear wheels must be fitted with tires with similar tread patterns to prevent loss of control over the vehicle.

KTM 1190 RC8 R Specifications

General

Displacement	1195 cc
Bore x Stroke	105 mm x 69 mm
Compression Ratio	13.5:1
Transmission	6-speed
Rear Suspension	WP Monoshock
Fuel Tank Capacity	16.5 liters
Dry Weight	184 kg
Fuel System	Electronic fuel injection
Engine Type	V-twin, 4-stroke
Power	129 kW (175 hp) @ 10, 250 rpm
Torque	123 Nm @ 8, 000 rpm
Frame	Chromium-Molybdenum trellis frame, powder coated
Front Brake	2 x Brembo four-piston calipers, 320 mm discs
Rear Brake	220 mm disc, 2-piston caliper
Seat Height	805 mm