14 ELECTRICAL SYSTEM 207
M00702-10
Main work
– Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test the rest potential and start potential of the
battery, and to test the alternator. With this device, you cannot overcharge the battery.
Info
Never remove lid
.
Charge the battery to a maximum of 10% of the capacity specified on battery
housing
.
– Switch off the battery charger after charging and disconnect from the battery.
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use
3 months
– Connect the negative cable with the battery.
Guideline
Screw, battery terminal M6 4.5 Nm
(3.32 lbf ft)
Finishing work
– Fit the seat. ( p. 170)
– Set the clock with SET CLOCK. ( p. 96)
To Next Page
Loading...
