Kyocera ECOSYS MA4500x

8-18
Setup and Registration (System Menu) > System Menu
Secure Settings
Ping
Restart Network
EnhncdVNC ov TLS -
Off/On Start Command Center RX and set for using TLS-protected remote operation.
*1, *3
Value: Off, On
NOTE
• The factory default setting is [On].
• If the setting is [On], a TLS certificate is required. The factory certificate is the
certificate owned by the machine.
Command Center RX User Guide
Port Number Specifies the port number used. The default port number is 9061.
*1
Value: 1 to 32767
NOTE
This function is displayed when [Off/On] is set to [On].
Available Net. -
Wi-Fi Direct
*2
Set whether to enable this function for each network.
Value: Disable, Enable
NOTE
This function is displayed when [Off/On] is set to [On].
Wi-Fi
*2
Wired Network
*1 The setting will be changed after restarting the device or network.
*2 Displayed only when the wireless network function is available on the machine.
*3 Set "TLS" to [On] in Secure Settings.
Secure Settings (page 8-18)
IMPORTANT
After changing the setting, restart the network or turn the machine OFF and then ON.
Item Description
TLS Select whether or not to use TLS.
Value: Off, On
Item Description
Ping Checks if communication with the destination by entering the host name or IP address of
the destination is possible.
NOTE
If [Primary Network] is set to [Option Network], this item is not displayed.
Item Description
Restart Network Restarts the network.
Item Description