Kyocera ECOSYS MA4500x - Page 410

10-30
Troubleshooting > Troubleshooting
1105 Failed to send via SMB. Check the following settings.
[System Menu/Counter] key > [System/Network]
> [Network Setting] > [ProtocolSettings] > [SMB]
page 8-14
Failed to send the e-mail. Select [On] of the SMTP settings on the Command
Center RX.
page 2-53
Failed to send via FTP. Check the following settings.
[System Menu/Counter] key > [System/Network]
> [Network Setting] > [ProtocolSettings] >
[FTP(Client)]
page 8-14
1106 Failed to send the e-mail. Check the sender address of SMTP on the
Command Center RX.
page 2-53
1131 Failed to send via FTP. Enable the TLS.
[System Menu/Counter] key > [System/Network]
> [Network Setting] > [Secure Protocol] > [TLS]
page 8-18
1132 Failed to send the e-mail. Check the following of the SMTP server.
• Is SMTP over TLS available?
• Is the encryption available?
Refer to the
Command
Center RX
User Guide.
Failed to send via FTP. Check the following of the FTP server.
• Is FTPS available?
• Is the encryption available?
—
2101 Failed to send via SMB. Check the network and SMB settings.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
• Host name and IP address
• Port number
—
Failed to send via FTP. Check the network and FTP settings.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
• Host name and IP address
• Port number
—
Failed to send the e-mail. Check the network and Command Center RX.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
• POP3 server name of the POP3 user
•SMTP server name
page 2-53
Error
Code
Message Corrective Actions
Reference
Page