Lantronix SLC 8000

To Next Page

To Previous Page

8: Device Ports

SLC™ 8000 Advanced Console Manager User Guide 136

Figure 8-7 Device Ports > RPMs - Add Device

Main Page

Default Chapter1
- User Guide1
- Intellectual Property2
- Warranty2
- Contacts2
- Open Source Software2
- Disclaimer & Revisions3
- Revision History4
- Table of Contents5
  - List of Figures14
  - List of Tables18
1 : about this Guide19
- Purpose and Audience19
- Summary of Chapters19
- Additional Documentation20
2 : Introduction21
- Features21
  - Console Management21
  - Power22
- Hardware22
- Figure 2-1 SLC 8048 Unit (Front Side) - Part Number SLC 804812N-01-S23
- System Features24
  - Figure 2-2 SLC 8048 Unit Samples (Back Side) - Part Number SLC80482201S24
  - Access Control25
  - Configuration Options25
  - Device Port Buffer25
  - Protocols Supported25
  - Device Port and Console Port Interfaces26
- Figure 2-3 Three 16-Port USB I/O Modules Installed in Bays 1, 2, & 3 with Dual Ethernet Port27
- Figure 2-4 One 16-Port USB I/O Module Installed in Bay 1 with Dual Ethernet Port27
- Figure 2-5 One 16 RJ-45 Serial Port I/O Module Installed in Bay1 & Two 15 USB I/O Module Installed Bays 2 & 3 with Dual SFP Port27
- Figure 2-6 SFP Port Leds28
- Figure 2-8 Console Port (Front Side)28
- Table 2-7 Device (DCE Reversed & DTE) Port Pinout28
- Table 2-9 Console (DTE) Port Pinout28
- Figure 2-10 Dual Ethernet Network Connection29
- Figure 2-11 Inserting SFP Transceiver Module into the SFP por29
- Network Connections29
- Figure 2-12 Dual USB Ports30
- Figure 2-13 Memory Card Port30
- Front Panel USB Ports30
- Memory Card Port30
- Figure 2-14 Internal Modem Location31
- Internal Modem31
3 : Installation32
- What's in the Box32
- Technical Specifications34
- Figure 3-3 Product Label34
- Table 3-4 SLC Technical Specifications34
- Physical Installation36
4 : Quick Setup48
- Recommendations48
- IP Address48
- Table 4-1 Methods of Assigning an IP Address48
- Method #1 Using the Front Panel Display49
- Method #2 Quick Setup on the Web Page52
- Method #3 Quick Setup on the Command Line Interface55
- Figure 4-6 Quick Setup Completed in Web Manager55
- Figure 4-7 Home55
- Figure 4-8 Beginning of Quick Setup Script56
- Figure 4-9 Quick Setup Completed in CLI57
- Next Step58
5 : Web and Command Line Interfaces59
- Web Manager59
- Command Line Interface62
6 : Basic Parameters66
- Requirements66
- Network Port Settings67
- IP Filter74
- IP Filter Commands78
- Routing79
- Vpn80
- Figure 6-6 Network > VPN81
- Configuring an Ipsec VPN Tunnel through the CLI85
- Security86
- Figure 6-7 Network > Security87
7 : Services89
- System Logging and Other Services89
- Ssh/Telnet/Logging90
- Snmp94
- NFS and SMB/CIFS98
- Secure Lantronix Network101
- Date and Time107
  - Figure 7-10 Services > Date & Time108
  - Date and Time Commands109
- Web Server110
- Igoogle Gadgets116
- Figure 7-14 Igoogle Gadget Example117
8 : Device Ports118
- Connection Methods118
- Permissions118
- I/O Modules119
- Table 8-1 Supported I/O Module Configurations119
- Device Status120
- Figure 8-2 Devices > Device Status120
- Device Ports121
- Device Ports - Settings123
- Interacting with a Device Port141
- Device Ports - Logging and Events142
- Console Port148
  - Figure 8-11 Devices > Console Port148
  - Console Port Commands149
- Internal Modem Settings150
- Host Lists155
- Scripts159
- Sites174
- Figure 8-21 Devices > Sites175
- Modem Dialing States178
9 : USB/SD Card Port184
- Set up of USB/SD Card Storage184
- Manage Files191
- Figure 9-5 Firmware and Configurations - Manage Files191
- USB Commands192
- SD Card Commands192
10 : Remote Power Managers193
- Devices - Rpms193
- Rpms - Manage Device199
- Figure 10-8 Rpms - Managed Device199
- Rpms - Outlets202
- Figure 10-9 Rpms - Outlets202
- RPM Shutdown Procedure203
- Optimizing and Troubleshooting RPM Behavior205
- RPM Commands206
11 : Connections209
- Typical Setup Scenarios for the SLC Unit209
12 : User Authentication217
- Figure 12-1 User Authentication > Authentication Methods218
13 : Maintenance271
- Firmware & Configurations271
- Audit Log283
- Email Log284
- Figure 13-5 Maintenance > Audit Log284
- Figure 13-6 Maintenance > Email Log285
- Diagnostics286
- Status/Reports291
- Emailing Logs and Reports293
- Figure 13-11 Emailed Log or Report294
- Figure 13-12 about SLC295
- Events296
  - Figure 13-13 Maintenance > Events296
  - Events Commands298
- Lcd/Keypad299
  - Figure 13-14 Maintenance > Lcd/Keypad299
  - Lcd/Keypad Commands300
- Banners301
  - Figure 13-15 Maintenance > Banners301
  - Banner Commands302
14 : Application Examples303
- Telnet/Ssh to a Remote Device303
- Figure 14-1 SLC - Console Manager Configuration303
- Figure 14-2 Remote User Connected to a SUN Server Via the SLC Unit303
- Dial-In (Text Mode) to a Remote Device305
- Figure 14-3 Dial-In (Text Mode) to a Remote Device305
- Local Serial Connection to Network Device Via Telnet306
- Figure 14-4 Local Serial Connection to Network Device Via Telnet306
15 : Command Reference308
- Introduction to Commands308
  - Command Syntax308
  - Table 15-1 Actions and Category Options308
  - Command Line Help309
  - Tips309
- Administrative Commands310
- Audit Log Commands323
- Authentication Commands324
- Kerberos Commands325
- LDAP Commands326
- Local Users Commands327
- NIS Commands331
- RADIUS Commands332
- TACACS+ Commands333
- User Permissions Commands334
- Remote User Commands336
- CLI Commands337
  - Description338
- Connection Commands339
- Custom User Menu Commands343
- Date and Time Commands345
- Device Commands346
- Device Port Commands347
- Diagnostic Commands351
- Events Commands355
- Group Commands356
- Host List Commands357
- Internal Modem Commands358
- IP Filter Commands359
- Logging Commands360
- Network Commands363
- NFS and SMB/CIFS Commands366
- Routing Commands368
- RPM Commands368
- SD Card Commands371
- Security Commands371
- Services Commands372
- SLC Network Commands373
- SSH Key Commands374
- Status Commands377
- System Log Commands378
- USB Access Commands379
- USB Device Commands379
- USB Storage Commands380
- USB Modem Commands382
- VPN Commands383
Appendix A: Security Considerations387
- Security Practice387
- Factors Affecting Security387
Appendix B: Safety Information388
- Safety Precautions388
Appendix C: Adapters and Pinouts390
- Figure C-1 RJ45. Receptacle to DB25M DCE Adapter for the SLC Unit (PN 200.2066A)390
- Figure C-2 RJ45 Receptacle to DB25F DCE Adapter for the SLC Unit (PN 200.2067A)391
- Figure C-3 RJ45 Receptacle to DB9M DCE Adapter for the SLC Unit (PN 200.2069A)391
- Figure C-4 RJ45 Receptacle to DB9F DCE Adapter for the SLC Unit (PN 200.2070A)392
- Figure C-5 RJ45 Receptacle to DB25M DTE Adapter (PN 200.2073)392
Appendix D: Protocol Glossary393
Appendix E: Compliance Information395
- Rohs, REACH and WEEE Compliance Statement396

Table of Contents

Other manuals for Lantronix SLC 8000

Related product manuals