Lantronix SLC 8000

15: Command Reference
SLC™ 8000 Advanced Console Manager User Guide 368
Description
Displays NFS share settings.
Routing Commands
set routing
Syntax
set routing [parameters]
Parameters
rip <enable|disable>
route <1-64> ipaddr <IP Address> mask <Netmask> gateway <IP Address>
static <enable|disable>
version <1|2|both>
Description
Configures static or dynamic routing.
To delete a static route, set the IP address, mask, and gateway parameters to 0.0.0.0.
show routing
Syntax
show routing [resolveip <enable|disable>] [email <Email Address>]
Description
Sets the routing table to display IP addresses (disable) or the corresponding host names (enable).
You can optionally email the displayed information.
RPM Commands
set rpm add
Syntax
set rpm add <RPM Name>
Description
Adds an RPM to be managed (prompts will guide selection of RPM vendor and model).