Lantronix SLC 8000

12: User Authentication
SLC™ 8000 Advanced Console Manager User Guide 232
NIS Commands
These commands for the CLI correspond to the web page entries described above.
To configure the SLC unit to use NIS to authenticate users who log in via the Web, SSH,
Telnet, or the console port:
set nis <one or more parameters>
Parameters
allowdialback <enable|disable>
breakseq <1-10 Chars>
broadcast <enable|disable>
clearports <Port List>
dataports <Port List>
dialbacknumber <Phone Number>
domain <NIS Domain Name>
escapeseq <1-10 Chars>
listenports <Port List>
master <IP Address or Hostname>
slave1 <IP Address or Hostname>
slave2 <IP Address or Hostname>
slave3 <IP Address or Hostname>
slave4 <IP Address or Hostname>
slave5 <IP Address or Hostname>
state <enable|disable>
To set group and permissions for NIS users:
set nis group <default|power|admin>
To set permissions for NIS users not already defined by the user rights group:
set nis permissions <Permission List>
where
<Permission List> is one or more of nt, sv, dt, lu, ra, sk, um, dp, do,
ub, rp, rs, rc, dr, wb, sn, ad, md, sd
To remove a permission, type a minus sign before the two-letter abbreviation for a user
right.
To set a default custom menu for NIS users:
set nis custommenu <Menu Name>
To view NIS settings:
show nis