14: Application Examples
SLC™ 8000 Advanced Console Manager User Guide 306
5. Connect to the SUN Unix server using the direct command.
[SLC]> connect direct deviceport 2
SunOS 5.7
login: frank
Password:
Last login: Wed Jul 14 16:07:49 from computer
Sun Microsystems Inc.SunOS 5.7Generic October 1998
SunOS computer 5.7 Generic_123485-05 sun4m sparc SUNW,SPARCstation-20
$
6. Use the escape sequence to escape from direct mode back to the command line interface.
Local Serial Connection to Network Device via Telnet
This example shows a terminal device connected to an SLC device port, and a Sun server
connected over the network to the SLC device. When a connection is established between the
device port and an outbound Telnet session, users can access the Sun server as though they
were directly connected to it. (See Chapter 11: Connections on page 209).
Figure 14-4 Local Serial Connection to Network Device via Telnet
In this example, the sysadmin would:
1. Display the current settings for device port 2:
[SLC]> show deviceport port 2
___Current Device Port
Settings________________________________________________
Number: 2 Name: Port-2
Modem Settings-------------Data Settings-----------IP Settings-------
Modem State: disabled Baud Rate: 9600 Telnet: disabled
Modem Mode: text Data Bits: 8 Telnet Port: 2002
Timeout Logins: disabled Stop Bits: 1 SSH: disabled
Local IP: negotiate Parity: none SSH Port: 3002
Remote IP: negotiate Flow Control: xon/xoff IP: <none>
Authentication: PAP Logins: disabled
CHAP Host: <none> Break Sequence: \x1bB
CHAP Secret: <none> Check DSR: disabled
NAT: disabled Close DSR: disabled
Dial-out Login: <none>
Dial-out Password: <none>
Dial-out Number: <none>
Dial-back Number: usernumber
Initialization Script: <none>
Internet
Serial Cable
to Device Port 2
Sun UNIX Server
SLC 8000 Advanced Console Manager
To Next Page
Loading...
Need help?
General
Weight and Dimensions
