Lantronix SLC 8000

12: User Authentication
SLC™ 8000 Advanced Console Manager User Guide 243
Parameters
allowdialback <enable|disable>
breakseq <1-10 Chars>
clearports <Port List>
dataports <Port List>
dialbacknumber <Phone Number>
escapeseq <1-10 Chars>
listenports <Port List>
state <enable|disable>
usevsa <enable|disable>
To identify the RADIUS server(s), the text secret, and the number of the TCP port on the
RADIUS server:
set radius server <1|2> host <IP Address or Hostname> secret <Secret>
[port <TCP Port>]
The default port is 1812.
To set the number of seconds after which the connection attempt times out:
set radius timeout <disable|1-30>
May be 1-30 seconds.
To set user group and permissions for RADIUS users:
set radius group <default|power|admin>
To set permissions for RADIUS users not already defined by the user rights group:
set radius permissions <Permission List>
where
<Permission List> is one or more of nt, sv, dt, lu, ra, sk, um, dp, do,
ub, rp, rs, rc, dr, wb, sn, ad, md, sd
To remove a permission, type a minus sign before the two-letter abbreviation for a user
right.
To set a default custom menu for RADIUS users:
set radius custommenu <Menu Name>
To view RADIUS settings:
show radius
User Attributes & Permissions from LDAP Schema or RADIUS VSA
Remote user attributes (group/permissions and port access) can be obtained from an Active
Directory server's schema via the user attribute 'secureLinxSLCPerms', or from a RADIUS server's
Vendor-Specific Attribute (see below). This attribute is a set of parameter-value pairs. Each
parameter and value is separated by a space, and a space separates each parameter-value pair.
Whitespace is not supported in the value strings. The parameters that are supported are: