Lantronix SLC 8000

15: Command Reference
SLC™ 8000 Advanced Console Manager User Guide 372
Parameters
set security <parameters>
fipsmode
Parameters
fipsmode <enable|disable>
show security
Description
Displays security settings and current status.
Parameters
show security
Services Commands
set services
Syntax
set services <one or more services parameters>
Parameters
netlog <off|error|warning|info|debug> auditlog <enable|disable>
authlog <off|error|warning|info|debug> auditsize <1-500 Kbytes>
diaglog <off|error|warning|info|debug> clicommands <enable|disable>
servlog <off|error|warning|info|debug> includesyslog <enable|disable>
devlog <off|error|warning|info|debug> snmp <enable|disable>
genlog <off|error|warning|info|debug> v1v2 <enable|disable>
syslogserver1 <IP Address or Name> traps <enable|disable>
syslogserver2 <IP Address or Name> trapversion <1|2|3>
rpmlogsize <5-40 Kbytes> nms1 <IP Address or Name>
otherlogsize <5-400 Kbytes> nms2 <IP Address or Name>
telnet <enable|disable> alarmdelay <1-6000 Seconds>
timeouttelnet <disable|1-30 minutes> location <Physical Location>
telnetdatadir <netin|netout|both> contact <Admin Contact Info>
webtelnet <enable|disable> rocommunity <Read-Only
Community>
escapeseqtelnet <1-10 Chars> rwcommunity <Read-Write
Community>
outgoingtelnet <enable|disable> trapcommunity <Trap Community>
ssh <enable|disable> v3user <v3 RO User>
portssh <TCP Port> v3rwuser <v3 RW User>
v1ssh <enable|disable> v3trapuser <v3 Trap User>