Lantronix SLC 8000

15: Command Reference
SLC™ 8000 Advanced Console Manager User Guide 359
initscript <Modem Init Script>
nat <enable|disable>
chapauth <chaphost|localusers>
checkdialtone <disable|5-600 min>
dialbacknumber <usernumber|Phone Number>
dialoutnumber <Phone Number>
dialbackdelay <PPP Dialback Delay>
dialoutlogin <Remote User Login>
dialbackretries <1-10>
Set the modem password and CHAP secret (any extra parameters will be ignored):
set intmodem dialoutpassword
set intmodem chapsecret
Note: It is recommended that the initscript be prepended with 'AT' and include
'E1 V1 x4 Q0' so that the SLC may properly control the modem.
Display settings for the internal modem:
show intmodem
IP Filter Commands
set ipfilter state
Syntax
set ipfilter state <enable|disable> [testtimer <disable|1-120 minutes>]
Description
Enables or disables IP filtering for incoming network traffic.
set ipfilter mapping
Syntax
set ipfilter mapping <parameters>
Parameters
ethernet <1|2|bond0> state <disable>
ethernet <1|2|bond0> state <enable> ruleset <Ruleset Name>
deviceport <1..48> state <disable>
deviceport <1..48> state <enable> ruleset <Ruleset Name>
usbport <U1|U2> state <disable>
usbport <U1|U2> state <enable> ruleset <Ruleset Name>
internal modem state <disable>
internal modem state <enable> ruleset <Ruleset Name>