After you finish
• Install a replacement unit. See “Install the power distribution board” on page 196.
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the power distribution board
Follow instructions in this section to install the power distribution board.
About this task
Attention: Read “Installation Guidelines” on page 121 and “Safety inspection checklist” on page 122 to
ensure that you work safely.
Watch the procedure. A video of the installation and removal process is available:
• YouTube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-BXei6L6c05osQVLt4w5XYx
• Youku: https://list.youku.com/albumlist/show/id_59636529
Procedure
Step 1. Install the power distribution board into the server.
a.
Align the connector on the power distribution board with that on the system board with the
two power supply connectors facing the power supply bays; then, press the power distribution
board into the connector until it is fully seated.
b.
Fasten the three screws to secure the power distribution board to the system board.
Figure 137. Installing the power distribution board
After you finish
196 ThinkSystem SR670 V2 Maintenance Manual
To Next Page
Loading...
