• YouTube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-BXei6L6c05osQVLt4w5XYx
• Youku: https://list.youku.com/albumlist/show/id_59636529
Procedure
Step 1. Placing the system board inside the chassis.
a.
Grasp the lifting handles on system board, and tilt the system board so that its rear end is
up.
b.
Align the guide slot on system board with the guide pin on chassis; then, lower the system
board into the chassis.
1 Lifting handle
Step 2. Grasp the lifting handles, and slide the system board toward the rear of the chassis. Make sure
that:
1. The guide pin is at the front end of the guide slot.
2. The rear connectors on the new system board are inserted into the corresponding holes in the
rear panel.
Chapter 4. Hardware replacement procedures 219
To Next Page
Loading...
